Output Voltage: | 144V |
---|---|
Certification: | FCC, CE, RoHS, ISO |
Color: | Black |
After-Sales Service: | Have |
Kw: | 3.3kw |
V: | 144V |
Samples: |
---|
Customization: |
---|
Suppliers with verified business licenses
items | spec. and parameters | |
Spec |
Type |
HK-J-H66-40B |
Output Voltage |
48V | |
charging mode |
Response mode | |
Input |
Input voltage |
220VAC |
Input voltage range |
90~265VAC | |
Frequency |
50Hz | |
Frequency range |
45~65Hz | |
Inrush current |
≤16A | |
Input power factor |
≥0.99(@220Vin,Pomax) | |
Output |
Output power |
3.3KW |
(V) Range of output voltage |
55-100V | |
(A) Range of output current |
0~40A | |
Voltage regulation accuracy |
≤1% | |
Voltage ripple coefficient |
≤1% | |
Current regulation accuracy |
≤5% | |
Output response time |
≤5S | |
Typical efficiency |
≥94% | |
Environment |
Working temperature |
-40~55ºC |
Storage temperature |
-40~95ºC | |
humidity |
5%~95% | |
IP Level of IP |
IP67 | |
The cooling function |
Air cooling | |
Communication function |
CAN bus control (the charger can be charged normally after receiving the charging command; the charger is in standby state without command |
|
Protection |
Over voltage protection |
Input overvoltage, it will shut down, it can be self-recovery, output overvoltage, it will shut down, it can be self-recovery. |
Under voltage protection |
input under voltage, it will be shut down, it can be self-recovery, Output undervoltage, it will be shut down and can be self-recovery |
|
Short circuit protection |
output short circuit, it will shut down, it is self-recovery | |
Over temperature protection |
When the temperature of the heat sink is higher than 75 ºC, it reduces the output power. When the temperature is higher than 95 ºC, it disconnects the circuit. When the charging temperature recovers below 85 ºC, the charger recovers the output | |
Reverse connect protection |
The output is inversely connected. When it is powered on and does not start, it will give an alarm. When it is restored, it will work normally | |
Equilibrium potential and ground protection |
The resistance between the conductive parts that can be directly touched by the human body and the potential equalization point in the vehicle charger shall not be greater than 0.1Ω. The grounding point of the on-board charger should have an obvious grounding mark | |
Power-off protection |
Abnormal state, it will be cut off the power | |
Safety |
dielectricstrength |
Primary side - secondary side 3750VAC Primary side and secondary side - casing 1500vac |
Clearance and Creepage |
Primary side - secondary side 4mm / 6mm Primary side and secondary side - casing 2mm / 3mm |
|
Insulation performance |
20MΩ | |
harmoniccurrent |
Comply with gb17625 Requirements of 6.7.3.1 in 1-2003 | |
vibration resistance |
Through the frequency sweep vibration test in X, y and Z directions, the parts are not damaged and the fasteners are not loose | |
impact resistance performance |
Refer to the requirements in 6.5 of GB / t15139-1994 | |
Industrial solvent resistance |
Metal parts have good anti-corrosion coating | |
Salt fog resistance |
Refer to GB/T 2423.17 | |
Durability |
Not lower than the relevant provisions of GB / T 24347-2009 | |
Electromagnetic interference resistance |
Meet the requirements of 11.3.1 in GB / T 18487.3 | |
Electromagnetic abusive |
Meet the requirements of 11.3.2 in GB / T 18487.3 | |
Other |
OBC Net weight of charger |
5.1Kg |
Weight of charger plus packing box |
5.4Kg | |
Size of outer case |
345mm*285mm*200mm |
Suppliers with verified business licenses